Free. No signup. No row limits.

Cabinet door size calculator

Enter the opening and how the door sits. Get the door or drawer front size with the formula, and the stile, rail and panel sizes for five-piece doors.

Units
Door mount
Making
Reveals, gaps and door style
Default to confirm: assumption, no source yet
Default to confirm: assumption, no source yet
Default to confirm: assumption, no source yet
Default to confirm: assumption, no source yet
Default from source. S4: partial overlay often 1/2 in
Default from source. S3: AWI nominal 3.2 mm
Default from source. S4 worked example: 2 1/4
Default from source. S4 worked example: 2 1/4
Default from source. S4 worked example: 3/8
Default from source. S4 worked example: 1/16
  • Door22 x 28D-1

    Door = (W_op + 2O) x (H_op + 2O) = (21 + 1) x (27 + 1) = 22 x 28

Opening 21 wide by 27 high.

Tap a result to see its formula with your numbers. Verify against your own materials and hardware before cutting.

Build the whole cabinet

Email me this result

Optional. We send one email with a link that restores this on any device. It is not needed to use the tool.

We use your address to send this link and, only if you ticked the box, tips. See the privacy policy.

How it is calculated

A door is sized from the opening it covers. With a face frame and overlay doors, each door is the opening plus the overlay on every edge: W_door = W_op + 2 x O and H_door = H_op + 2 x O (rule D-1). The default overlay is 1/2 inch, which matches the partial-overlay figure on the inchcalculator.com door calculator.

A pair of overlay doors with no centre stile shares the opening and leaves a gap between them: W_door = (W_op + 2 x O - G_pair) / 2 (D-2). The default gap is 1/8 inch (3.2 mm), the AWI nominal figure quoted in the WoodWeb knowledge base. With a centre stile each door covers its own half opening (D-3).

Inset doors sit inside the opening with a gap on every edge, 1/16 inch by default: W_door = W_op - 2 x G_in (D-5), and a pair is (W_op - 3 x G_in) / 2 (D-6).

Frameless full-overlay doors are sized from the cabinet: the width is the cabinet width minus a reveal on each side, and a pair is (W - 2 x rev_side - gap_pair) / 2 (D-8, D-11). With the metric defaults that is the cabinet width minus 6 mm, divided by two, the rule a WoodWeb contributor gives for 3 mm between double doors.

Five-piece doors add stiles of the door height, rails of W_door - 2 x S_d + 2 x g_d and a panel with an expansion gap (D-12 to D-14), after the worked example on inchcalculator.com. Every number here is a setting, so change the overlay, gaps and stile width to match how your shop builds.

Worked example with your current numbers: a 21 by 27 opening gives the sizes in the result above.

Build your cabinet now

The calculators are small views of the cut list tool. Build the whole cabinet, free, no account.

Open the cut list tool